Self test menu

1. To enter the Self test menu press and hold "BYPASS" button.
2. Press PRESET 8 to increase test number.
3. Press PRESET 4 to decrease test number.
4. Press LOCK to enter a test and acknowledge OK result.
5. Press BYPASS to acknowledge bad result.

Note:The self test is described in the User Manual.

Reset menu & software load:

1. To enter the following functions hold WIZARD key while powering up the unit.
2. Once entered this menu navigation is as follows:
3. Press PRESET keys 4 and 8 to scroll in menu.
4. Press LOCK to confirm/enter.
5. Press BYPASS to cancel.

"L" - Load
Indicates Load mode and is used when loading application software.
Press LOCK (enter) to load the information present in the inserted PCMCIA card.

"R" - Reset
Press LOCK (enter) to reset the unit.
When LOCK is pressed once the "R" in the
display will start to flash and the unit is ready to
be reset.
You can now abort/cancel the operation by
pressing the BYPASS key or press LOCK a
second time to actually reset the unit.
While resetting a "+" is displayed.

"A" - Boot software version
Press LOCK (enter) to see current loaded boot software version.
For service-purposes only.

"V" - Operating software number
Press LOCK (enter) to see current loaded P2 software version.

"N" - Serial Number
Press LOCK (enter)to see serial number for this unit.

“ S” - Start
Reboots the P2 for normal use.
When rebooted after a Reset procedure has
taken place all Front Presets are reconfigured.
The reconfiguration process takes approx. 15
seconds during which the eight PRESET key
LEDs will flash. Be patient.

In the making!

Finish up:

1. Enter the self test menu.
2. Press all buttons and make sure all are working correctly.
3. Feed a signal through the unit and knock test it, listen for any sound changes, click or noise sounds.
4. Power OFF the unit by pressing and holding the "ON/OFF" button(Notice if the POWER LED blinks when in OFF state, its normal)
5. Power off and on a couple of times to ensure it starts up properly every time and check if the latest software is installed.